Mitsubishi Fuso 4m50 engine parts gasket kit me994672

4M50 Engine Overhaul Gasket Kit ME994672

Basic introduction to 4M50 engine

The 4M50 engine is a diesel engine produced by Mitsubishi Motors Corporation and is widely used in various commercial vehicles and construction machinery. The following is some basic introduction to the 4M50 engine:
1. Structure and displacement: The 4M50 engine adopts an in-line four-cylinder, four-stroke structure. The usual displacement is 4.9 liters (4908cc).
2. Fuel system: This engine uses a direct injection fuel system, which injects diesel directly into the cylinder through the injector. Direct injection technology improves combustion efficiency and power output while reducing fuel consumption and emissions.
3. Power and Torque: Specific power and torque outputs vary by vehicle model and trim. Generally speaking, the power of the 4M50 engine is between 140 and 175 horsepower, and the torque is between 400 and 520 N·m.
4. Technical features: The 4M50 engine uses turbocharging and intercooler technology to provide higher power output and fuel economy. The turbocharger increases intake airflow pressure, improving low-speed torque and power response. The intercooler cools the intake air, increases the oxygen density of the intake air, and further improves combustion efficiency.
5. Application scope: 4M50 engine is widely used in various commercial vehicles and engineering machinery, such as trucks, buses, engineering vehicles and excavators, etc. It is favored by the market for its reliability, durability and adaptability.
6. Maintenance and maintenance: For maintenance and upkeep of the 4M50 engine, it is recommended to perform regular maintenance in accordance with the manufacturer's service manual and recommendations. This includes changing oil and filters, checking and adjusting belt tension, cleaning and maintaining the cooling system, and more. Regularly check the condition of the gasket kit to ensure a good seal.

Gasket Kit Care Introduction

For 4M50 engine gasket kit maintenance, here are some suggestions:
1. Periodic Inspections: Periodically inspect the condition of the gasket kit, especially at the inspection points specified in the engine maintenance schedule. Check for oil leaks, coolant leaks or other signs of abnormalities.
2. Well-maintained cooling system: Ensure that the cooling system is operating properly and that the coolant level and quality meet requirements. Regularly check the cooling effectiveness of the coolant and the pressure of the cooling system to ensure that the gasket kit does not become overheated or overpressured.
3. Standardize engine oil maintenance: Change engine oil and oil filter regularly to maintain the lubrication performance inside the engine. Use the appropriate engine oil recommended by the manufacturer, adhering to change intervals and capacity requirements.
4. Avoid Overheating and Excessive Pressure: Avoid overheating the engine and excessively increasing pressure, which may cause damage to the gasket kit. Follow the manufacturer's recommended operating and loading requirements.
5. Pay attention to the tightness: If leakage or failure is found in the gasket set, it should be repaired or replaced in time. Make sure the gasket kit has a good seal to prevent fluid or gas leaks and further damage to engine components.
6. Regular maintenance and cleaning: Perform regular engine maintenance and cleaning to ensure parts around the gasket kit are clean and remove accumulated dirt and oil.

Company Profile